Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sourav
The best way to initialize a register is
SR Rx,Rx
instruction.
There are other ways as well, few of them are already
posted.
| Is This Answer Correct ? | 11 Yes | 5 No |
Post New Answer View All Answers
Explain the difference between various read and find statement and which one should be used when for better adabas performance?
What is maximum displacement?
What is need of start 0?
Explain how to produce soc7 abend?
How to pass the parameters from jcl to assembler program?
What is need of start 0? In steed of can we use anyother numerics? If we use what will happen?
Explain the difference in data type "x" and "p"?
Explain how to access vsam file?
What does the following code do? Ap wkur,=p5 where wkur is a label?
Explain the difference between various read and find statement?
What is the use of trt instruction?
In the house keeping section of an MVS assembly language program, like the one below STM R14,R12,12(R13) BASR R12,R0 USING *,R12,R11 LA R11,2048 LA R11,2048(R11,R12) .... .... 1. What if BASR R12,R0 IS NOT PRECEDE USING *,R12,R11? 2. USING (base address), REGISTER does USING directive says assembler to treat particular Register as a base register with the mentioned base address..in the above case * i.e current location counter..well if that is the case why we need BASR R12,R0 ? 3. What if I write like STM R14,R12,12(R13) BASR R12,R0 LA R11,2048 LA R11,2048(R11,R12) USING *,R12,R11 there is no address resolution being calculated in both LA statements so is it a right way to set Base register?..will there be any issues with Domain regarding R11 and R12?
How many maximum base registers we can have in a program?
explain about maximum displacement and how to cross this limit?
how to pass the parameters from jcl to assembler pgm?
