How silicon gel sucks moisture in the transformer, its have
any small exaust fan behind silicon gel.
- 4 Answers
- 6156 Views
- I also Faced
- E-Mail Answers
Answer Posted / raven
it is placed in long cylinder which is internally connected
to transformer.This gel absorbs any moisture preset in
transformer,it changes its color/state indicating it is time
to replace the gel with a new one.There is no fan present
near silicon gel as far as i know.I visited loco shed of
railways where there are huge transformers.
Well i hope this is correct. :)
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Why 11kv to be generated in generation station
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
What is meant by stator? What is meant by rotor?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
what is a power factor?
how to ctrl motor by use of ac or dc drive.plz explain evdintly
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
what is electrical machines
how generator load test is conducted?what are the steps?
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
Discuss about gear cutting machines.
what kelvin's law ?
