Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sindhu
fuse rating is selected depending upon the rated current
which will be specified in the name plate details of the
motor.
usually for load test,
fuse rating=(125\100)*rated current
| Is This Answer Correct ? | 31 Yes | 8 No |
Post New Answer View All Answers
What is the formula to calculate the rating of power cable for three phase current.
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
What is the resonant peak?
what is meant by twilight switches 7 where its applicable ?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
What is order of the system?
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
How to Calculate the Fault Level of Electrical Installation
Write a note on Treatment for electric shock.
What Normal(Tangent) towers and Tension(Cut-point) Towers?
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
how to calculate singlephase motor efficiency?
