Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between the diode and the rectifier
- 17 Answers
- 44415 Views
- Avalon, L&T, Mahacol Trexim, I also Faced
- E-Mail Answers
Answer Posted / m.numan akram
dude....!
diod and rectifier is the same thing.....
there is no different between them....
diod is also the rectifier who is used for
rectification...and rectification is a proccess in which we
used rectifier to convert the AC voltages to DC voltages...
and we can say that it is used to purify the the AC cycle
or minimize the ripples...
| Is This Answer Correct ? | 19 Yes | 10 No |
Post New Answer View All Answers
show the single line diagram of star delta starter with single phase preventer
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
what is differentila pilot supervision in the incomer control panel in the power station?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
What is slope...? Explain slope 1 and slope 2...?
WHAT IS DEAD END IN PROTECTION?
How much load can be taken for chiller from 1500 kva transformer
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
what parameters are should nessary for control technic dc drive(in rolling mills)?
sir please send me techinical questions for junior engineer posting in bangalore railway i am diploma holder
how can get electrical "c" licence.i am complited in DEEE.PASSING YEAR OF 1993.WORKING IN PVT COCERN LT LINE.PLEASE ADVISE ME .CELL NO 9994786021
how to calculate transformer load?
which pump used in STP
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
