Interested to Buy Any Domain ? << Click Here >> for more details...
WHY DOES NEUTRAL DO NOT CARRY EVEN THOUGH IT CARRIES RETURN
CURRENT?
- 4 Answers
- 9941 Views
- I also Faced
- E-Mail Answers
Answer Posted / pratheesh
In three phase system, if the loads on all three phases are
equal, there will not be any current flow through neutral.
Remember the star point of motor. I1+I2+I3=0. If there is
no potantial in neutral with respect to ground, there will
not be any current flow.
But if the loads on any phase/s are not equal to others,
I1+I2+I3 is not equal to 0. So in this case there will be
some potential on neutral wire at the load side and this
will creat a current flow to the star point of trasformer.
| Is This Answer Correct ? | 19 Yes | 1 No |
Post New Answer View All Answers
A 400 V, 50 Hz, Δ connected synchronous generator has a field reactance of 0.1 Ω and armature resistance of 0.015 Ω. At full load, the machine supplies 1200 A at 0.8 pf lagging. Under full-load conditions, the friction and windage losses are 40 KW and the core losses are 30 KW. What is the machine’s overall efficiency? Ignore any field circuit losses.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what is sustainable current of any conductors . a bare busbar or pvc cable has different sustainable current .
If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?
Why CBCT rating is 50/1A
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
What is the unit of attenuation?
what are the safety measures of induction motor?
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
What is deference between MCB & MCCB & ISOLATOR
is it value of power factor is more than unit. whats effects in the source supply
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
What is the maximum operating temperature for a thermoplastic insulated cable?
