what is phase to phase fault? what is line to line fault?
- 2 Answers
- 5871 Views
- Phoenix Technologies, I also Faced
- E-Mail Answers
Answer Posted / rabi
Both are same.
line-to-line fault occurs when any two phases get shorted.
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
ratings of lightning arrester
How many kw will suply from one db
List of equipments required foe industrial repair lab.
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
DERIVE AN EXPREION FOR MAXIMUM POER TRANSMISSION, WHAT ARE ITS APPLICATIONS.
Why armature rheostat is kept in maximum position?
Why is a synchronous motor always star connected??
How to calculate impedance volt in Transformer?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
What is the test block protection relay if any body know plz explained
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.
can i use 2000/5A Clamp meter to measure HT cable
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
