Interested to Buy Any Domain ? << Click Here >> for more details...
what is the purpose of starter in tube light?what is it
operation .
- 1 Answers
- 5092 Views
- I also Faced
- E-Mail Answers
Answer Posted / rabi
When starting the lamp, a glow discharge will appear over
the electrodes of the starter. This glow discharge will
heat the gas in the starter and cause the bi-metallic
electrode to bend towards the other electrode. When the
electrodes touch, the two filaments of the fluorescent lamp
and the ballast will effectively be switched in series to
the supply voltage. This causes the filaments to glow and
emit electrons into the gas column by thermionic emission.
In the starter's tube, the touching electrodes have stopped
the glow discharge, causing the gas to cool down again. The
bi-metallic electrode also cools down and starts to move
back. When the electrodes separate, the inductive kick from
the ballast provides the high voltage (about 1 KV) to start
the lamp.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
BRIEFLY EXPLAIN THE STORAGE CLASSES AND THEIR TYPES IN C
State the factors, for the choice of electrical system for an aero turbine.
what is the maximum temperature rating of a thhn insulated conductor?
what is high - pot test. what's its use?????
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
What are the various types of BUSBAR Schemes? explain each
What are stable systems?
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
As we use capacitor bank in 3ph ckt to improve PF, can we use capacitor in single ph domestric use, in house we have Fan,Mixer,electric cooker,iron,tube choke they also lag the system,because it is inductive load. if it is possible to improve PF of single ph system-- if yes- type of capacitor to be used,connection diagram, working in detail. if no-- list it.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
What is the difference between resistance grounding system and resistance earthing system?
