Answer Posted / akash
NC is used for the numerical controlled machines.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How can I weld A234 WPB and WPB P11 fitting? Any special heat treatment required? What happen if I weld both?
Which element causes difference in higher and lower heating values of fuel ?
"In refrigeration, why during operations is running low pressure at the suction side?"
What is a uniformly distributed load?
DAE Mechanical engineering interview questions
WHAT IS THE DIFFERENCE B/W LUBE OIL 20 W 40 AND 20 W 40 OIL.
What is an oil mist detector
Will a steel cable become longer if it is heated while under load?
How engine design needs to be changed to burn lean mixture ?
Specific strength of materials is very high when they are in fibre size but lower when they are in bar form why ?
Who has the most influence in ur life? & in which way?
hi sir my name is srikanth plz send me question papers
What is the normal vacuum pressure in a steam turbine atmospheric condenser? What would cause the press to falls?
What is the turbine and how does it work?
What are to be checked in an induction motor?