what is the differance between Horizental and vertical heat
exchanger?
- 11 Answers
- 36704 Views
- Bihar Caustic and Chemicals, I also Faced
- E-Mail Answers
Answer Posted / muthu
same
| Is This Answer Correct ? | 10 Yes | 32 No |
Post New Answer View All Answers
What is the method involved in analyzing powders for composition?
how will we calculate the heat of formation through electron...??
Why is double the amount of gas collected in one of the test tubes in electrolysis of water than th amount collected in the other? Name this gas?
could anyone send me model question papers or outline of graduate trainee(chemical engg) post?
What is a cstr and what are its basic assumptions?
What are the some common problems associated with dense phase pneumatic conveying?
Is there a quick rule-of-thumb to estimate a gas side heat-transfer rate inside the tubes of a shell and tube heat exchanger?
Should slurry pipes be sloped during horizontal runs?
Explain under what circumstances are vortex flowmeters the most accurate?
What are the customization steps in sap?
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
In a crusher where is the energy provided to it is used up for?
Explain what types of valves are recommended for slurry services?
Are there any special considerations to be taken into account for combustion ammonia?
What's -74C, dew point is better the -70C dew point In draying unit .
