what is the method of electric earth for the protection of
low voltage electric equipment
- 1 Answers
- 4916 Views
- MacLellan, Shiva Corporation, Siemens, I also Faced
- E-Mail Answers
Answer Posted / sheik
megger
| Is This Answer Correct ? | 3 Yes | 16 No |
Post New Answer View All Answers
What is order of the system?
how we can calcultae the short circuit level for bus bar
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
Define branch?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how technical is calculated in 11kv line and lt line
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
Leakage current,un balance current which relay using for high voltage transmission?
for 750 kw LT load what will be the ht kva
Which motor will you choose which can operate in both lagging as well as leading power factors?
