why we step down the voltage from 440 to 220 in machines
Answer Posted / ashutosh
b/c if voltage decreases therefore the current is increases
due to p=v*i & hence if current is increases therefore the
magnetic flux will also increases & hence there is good
magnetic strength will occurs
Is This Answer Correct ? | 2 Yes | 10 No |
Post New Answer View All Answers
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
What is the suitable transmission voltage?
why tertiary winding is used in transformer with diagram?
How to improve fuel cell in a distribution system?
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
how to find out 3 phase complex power in per unit in unbalanced system?
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
Type of motor stater detail and working detail
When will you multiply and devide with derating factors to the actual value while sizing the cable?
What are the factors influence the choice of an electrc drive?
how to calculate power consumption in slip ring motor at different step