Interested to Buy Any Domain ? << Click Here >> for more details...
In india the power supply is always in multiple of 11,
eg.220 V, 440 V...
what is the reason?
- 11 Answers
- 25869 Views
- BSES, Electrical, L&T, PSIT, I also Faced
- E-Mail Answers
Answer Posted / ashu
DEAR
THE FORM FACTOR FOR A PURE SINE WAVE IS 1.1
SO, THE power supply is always in multiple of 11,
eg.220 V, 440 V...
| Is This Answer Correct ? | 61 Yes | 6 No |
Post New Answer View All Answers
What is an ideal transformer?
How CFL &T5 tube light glows?
would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
what is cathodic protection and why it use in industries?
what is ps impedance test
In AC if the direction of current keeps reversing every half cycle, how does it propogate through the transmission lines?
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Why did lightening arrestor solid copper rod head is sharp on mobile tower top?
