how many type of of electrical fuse please explan?
Answer Posted / jagadisha.bmsit
Various types of fuses are:
1. Expulsion fuse
2. Rewirable fuse
3. Cartridge fuse
4 Drop-out fuse
5. liquid fuse
6. open fuse
7 Striker fuse
8. Switch Fuse
9. HRC fuse
Is This Answer Correct ? | 82 Yes | 13 No |
Post New Answer View All Answers
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
Rules and standards of electrical control wiring ?
What we mean by vintage of an engine+Generator?
Why armature rheostat is kept in maximum position?
what is meant by surge? what we called for high currents?
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
What happened ,If 3 phase clearance not maintained in 33KV Line,11KV LIne etc?
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what are the reasons of CT circuit faulty in busbar protection scheme?
what is your majour contributions in your present job
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
what are the range of memory address in plc for L&T lx7 4A
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
what is the cause of voltage dipp or swell in the transmission lines?