Interested to Buy Any Domain ? << Click Here >> for more details...
I WANT TO KNOW SOME BASIC CONCEPTS RELATED TO
INSTRUMENTATION
- 4 Answers
- 31696 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravi prakash
Before knowing the concepts, one should know, what
instrumentation is.
In simple sense, instrumentation is art rather than a
science of taking measurements.
Now you can think of all the posible ways to measure a
physical parameter.
take example of measuring flow rate of any fluid.
the flow of fluid is proportional to the diffrential
pressure created when its flow is restricted, also the flow
is proportional to the amount of heat it can remove from a
hot source, or the change in frequency of ultasonic waves
made to pass in a flow, and also flow is proportional to
the voltage generated across electrodes when placed in a
magnetic field.... and the list goes on.
this was a small example to show that any fundamental can
be somehow related to a physical parameter, search for an
appropriate instrument compling in terms of cost, material
and technical specifications regarding the measureand.
The fundamental aim of instrumentation is to measure the
physical parameter and convert it into appropriate user
friendly form like digital readouts or graphical views.
And the book by B.G Liptak is Bible for instrumentation.
| Is This Answer Correct ? | 23 Yes | 1 No |
Post New Answer View All Answers
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
What is the minimum rating availalbe for weld neck orifice in market?
how can leve transmetter calibate in feild .and also put cv and flow plz .....
why we are using magnet for calibration of gas detector?
please send the sample qustion paper for iocl written test ..
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
Specify for Cables - Flame Retardant and Fire Resistant?
How would you choose differential range?
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
how works encoder in plc
Explain PID controller tuning & any one method used for it.
Explain bernoulli’s theorem. State its application.
