Interested to Buy Any Domain ? << Click Here >> for more details...
HAI,HOW TO SET THERMAL OVERLOAD RELAY FOR DOL STATRTER
FEEDER AT START AND RUNNING?
- 4 Answers
- 15326 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / mohit
set thermal overal relay to 95% of full load current of
motor.
| Is This Answer Correct ? | 6 Yes | 20 No |
Post New Answer View All Answers
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
what will happens if one phase is missing for 33/11kv power transfomer and why?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
distribution is maximum done by a)radial b)network c) parallel d)b & c
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
gas turbine genrator reactances
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
What are the relays in ACB and VCB
can someone explain that how the speed of the protection system affects the fault level calculation?
why ss stablity limit is more transient stablity limit?
why we use 630mm single core cable for transformer secondary side and why two neutral cable
How to calculate the sag on transmission Lines.
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
If short circuit ratio is high is it bad or good for a machine then tell the reason...
what are the things that can cause a three phase motor to crawl?
