what is the capital of india
- 13 Answers
- 16766 Views
- eInfochips, Reliance, I also Faced
- E-Mail Answers
Post New Answer View All Answers
how to avoid Saturation in C.T?
Why use in ht motore
what is ramping rate of generator
WHAT IS DIFFERENCE BETWEEN CAPACITOR AND CAPACITANCE?
Please define ohm’s law for a.c (alternating current)?
what & how to check the lightning arrester
how to select correct size of power cable for inverter duty motor
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
why does make gain margin and phase margin on same plot.?
what is the difference b/w ATS and HTS?
which of the following elements is not present in stainless steel
there are cam operated switches - why we call cam operated , What is cam ?
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
how we can calculate the efficiency of a diesel generator ?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
