Interested to Buy Any Domain ? << Click Here >> for more details...
What happen if LV supply is fed to a HT motor?
- 19 Answers
- 47908 Views
- ITC Infotech, Jindal, I also Faced
- E-Mail Answers
Answer Posted / mohit kochhar
if LT applied to HT motor then motor winding will burn out.
because motor current is inversely propotional to voltage.
i f applied less voltage the motor current will increase.
e.g.
1500 kw motor supply voltage 6.6 kV current 155 A.
if applied 415 V then current is around 2000A .
| Is This Answer Correct ? | 26 Yes | 63 No |
Post New Answer View All Answers
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
What is meant by reactance voltage?
Y phase plates are used in transmission line??? what is there need???
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
why we are not giving the zone 1 trip command to the master trip relay
How is the percentage impedence of a transformer fixed at design stage???
what is the responsibility of C license holder in industry?
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
why we r not earthed Control cable of C.T. terminals
Why back emf used for a dc motor? Highlight its significance.
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
how to test YNyn0 vector group in transformer?
how mass curve differs from hydrograph.
