WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL
CURRENT??
- 7 Answers
- 15416 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / vibol seng
I have agreed with answer No 4 any way in distribution
system we have met a lot time (80%) prepaire phase to phase
short circuit.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
how to build a network which step down 415v to 1v rms
can anyone provide me a amf panel control wiring using ec-2 relay?
how to carried out DAR test in 11 KV Alternator ?
Why does the adjacent zone of protection overlap?
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
Why CBCT rating is 50/1A
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
how to select energy meter? have any calculation?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
