Interested to Buy Any Domain ? << Click Here >> for more details...
Why a starter is used for a motor?
- 50 Answers
- 146656 Views
- L&T, Nilachal Polytechnic, I also Faced
- E-Mail Answers
Answer Posted / dimpal
intially motor starting current is very high. its 4-to 5
times of the rated current value. its higher value of the
cuarrent burs the winding of the motor so reduce the
startig current value we put the starter.starter function
is intially high resistance in the circuit so current its
reduceand we provide the protection.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
what are the things that can cause a three phase motor to crawl?
What is the drawback of class b amplifier?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
According to underground cables a) stress b/w sheath & conductor is high b) inrush of core & conductor
State and define ohm’s law?
how to calculate maximum current
What is frantic effect?
why single CT used in DOL starter power circuit?
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
Where can I get CPWD electrical specifications & Shedule of rates? Please help me
full form of flry b
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
