Interested to Buy Any Domain ? << Click Here >> for more details...
in three pin pluge there three pins one is phase and second
is earth third is nutral why nutral high diameter compare
with phase and earth
- 10 Answers
- 18906 Views
- Radiant, I also Faced
- E-Mail Answers
Answer Posted / abdul nazir
Earth pin diameter is bigger than phase & neutral, because
conductor area increases its resistance will be reduce, so
fault current will easily flow through this path, this is
the reason why earth pin is bigger than other two pins.
compare to other two pins, the earth pin LENGTH also more,
because every electrical equipment should earth first.
(safety reason).
And also we cant insert(by mistake) the earth pin to phase
hole(plug).
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
determine two methods to find loose connection in operational electrical system?
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
How to back charge the Gas turbine generator
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
What are the disadvantages of autotransformer?
given data are load current & power factor cable core size? plz any one update the calculation formula
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
If you have an earth with pilecap then your resistance is really low. why and how?
Write the force balance equation of ideal spring element.
How many gap between finger contact in a.c.b. and v.cb.?
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
How to select a transformer group to connect a 0,433 KV generation with 33 KV grid in bi directional flow of current
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how could we calculate the no of outgoings from a 800 watt distribution board
