Answer Posted / vikas v
Yes ,If it doesnt have input step down tfr.
| Is This Answer Correct ? | 13 Yes | 9 No |
Post New Answer View All Answers
v/f drive basic princeple
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
how do you test tachos and servos
why the India electrical supply transmission loss is high when compare to us
Z transform is use when system is not a) converges b) diverges
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
what is the internal working of star delta starter
how much leakage current is allowed in MC61A L&T make relay?
What is the difference between AC and DC injection methods for rotor earth fault protection
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
Why the earth to phase voltage is high 250 compare to other two phases
