Answer Posted / sayan
winding temperature measurement is carried out in an
indirect method in a power transformer. There is a CT which
replicates the current in the winding of any 1 of the
phases & heats up a heater using the secondary current of
the CT which in turn heats transformer oil in an enclosure.
This in turn causes delection in the winding temperature
indicator accordingly.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
why we r not earthed Control cable of C.T. terminals
What cmos is and its benefits?
What is the reason that the humming sound is coming from the induction furnace panel?
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
how is the incoming cable size calculated for a given current rating of a panel??
What is primary and backup protection?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
why electron produce magnetic field when it is in motion?
What is the most important precaution in any experiment with d.c. Shunt motor?
state types of reflectors in illumination engg. ???????
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
how we will deside the high voltage value
if a number of plc s are there then how many modbus to be used
Can double compression glands be used with regular cables?