Interested to Buy Any Domain ? << Click Here >> for more details...
Whats difference between a single phase & a three phase
motor?
- 4 Answers
- 16568 Views
- I also Faced
- E-Mail Answers
Answer Posted / p. naik
The starting circuit of of a3-phase motor has a contactor
wherein all the 3 phases of the supply are connected to it.
Whereas in 1-phase motors only 2 phases are required & the
third input of the contactor is looped from it's own
output.The main diffrence can be spoted in the power
diagram itself.
| Is This Answer Correct ? | 11 Yes | 12 No |
Post New Answer View All Answers
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
In radial network the source is fed from 1 end both ends at central
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
Leakage current,un balance current which relay using for high voltage transmission?
what is metering cum synchronizing panel and how it is used?
How stabilizer works??
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?
I completed my BE EEE degree 2006 .... which license should i apply .... ?????
What is the unit of charge and current?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
What Is HO factor in power selection
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
