why transformer ratings in kva?
Answer Posted / r. anand
Both the losses of the transformer is independent of the
power factor (cos phi), which means a transformer would not
make any change in the power factor, since both the losses
viz copper loss(depends on current) and iron loss(depends
on voltage) are independent of power factor, that is why a
Transformers rating is not on kW, but on KVA
Is This Answer Correct ? | 857 Yes | 99 No |
Post New Answer View All Answers
State the factors, for the choice of electrical system for an aero turbine.
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?
how to test power transformer.YNd11
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
what is the usage of microcontroller in the panel board?
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
how we explain parallel paths armature winding?
internally connection of photvoltic module
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
Phase control and integral control are used for?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
What is ramp signal?