Interested to Buy Any Domain ? << Click Here >> for more details...
HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN
ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii)
DELTA LOAD, USING A CLAMP METER.
NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO
WE GET?? PHASE CURRENT OR LINE CURRENT.
- 13 Answers
- 35931 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / rahul
u can find the phase current from the CT out going. then u
calculate the line current herewith
| Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
Why is voltage is required to be within permissible range for an electrical equipment?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what is two point starter?
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
What are linear and non-linear systems?
On what cycle does thermal power plant operate?
How can calculate the rating of a servo stabilizer for given a specific load
what is high - pot test. what's its use?????
pls tell me function of closing coil of A.C.B.
What are the basic component of a cro?
how we decide the require size is this for a known current at fuu load?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
