Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sudheer
if two generators synchronised and are punning parallel,
the total load divided and generator takes half of the
total load upon it.
some times because of load unbalancing one generator
shifts his total load on second generator and run as a
motor . before this condition the generator is taking load
upon him and now it will became as a load and it will run
as a motor insted of generator.
in this condition the second generator winding can be
damage, so we use reverse power relay. because the
direction changed of power , so we called it reverse
power .
| Is This Answer Correct ? | 86 Yes | 11 No |
Post New Answer View All Answers
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
Air refrigeration cycle works on the
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
Dry type transformers
What is the working mechanism of OLTC in Power Transformers????
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
Which type of a.c motor is used in the fan (ceiling fan, exhaust fan, pedestal fan, bracket fan etc) which are find in the houses ?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
how to modify DOL control panel into Delta Y connection?
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
how to calculate slip ring induction motor stator and rotor currents??
How to decide cable tray size?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Ceiling Fan and Storage type water heater. Discuss
