HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN
ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii)
DELTA LOAD, USING A CLAMP METER.
NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO
WE GET?? PHASE CURRENT OR LINE CURRENT.
Answer Posted / vivek
dear sudheer, the question was to find it out practically,
as i wrote, using the clamp meter ..... theory we all know
but thequestion is how to apply the knowledge .... let me
ask the question in a different way..... where exactly
would u put the clamp meter in order to measure the line
curren and phase current?? because phase current passes
through the neutral and the line current through two
phases. .... so i guess one might need to open theload or
the source especially in order to measure the phase
current ....if anybody knows a link from where i can get
practical knowledge like this then pl let me know....
thanks.
| Is This Answer Correct ? | 6 Yes | 11 No |
Post New Answer View All Answers
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
What is meant by analogous system?
testing of Vector Group – YNaoD II
what is difference between bus coupler and auto transfer switch
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
How can calculate the rating of a servo stabilizer for given a specific load
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
What is the technical difference between On delay timer and a Star delta timer?
Rules and standards of electrical control wiring ?
How to calculate fault level of 11 KV system
What is the function of the generator exciter?
which model T or pie model is prefarable in power syatem
what is meant by carrier aided trip protection in transmission line