Interested to Buy Any Domain ? << Click Here >> for more details...
why we step down the voltage from 440 to 220 in machines
- 4 Answers
- 6822 Views
- I also Faced
- E-Mail Answers
Answer Posted / srij21
It is the requirement of the machine.we can either operate
in 440 or 220 or even in 110 volts.The voltage depends upon
the motor,circuit and other loads related with the machine.
| Is This Answer Correct ? | 13 Yes | 2 No |
Post New Answer View All Answers
The screw thread commonly used for transmission of motion is one of the following types of threads
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
what is the difference between vector scale and vector diagram?
What is the difference between Droop vs Isoch Control?
Zone of protection and tripping scheme of arc protection relay.
how single phase preventer works ?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
What conditions are required for transformer to operate at low frequencies ?
How the annunciator works ? How to do its wiring
Draw a SLD of DG distribution up to main LT panel?
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
