Interested to Buy Any Domain ? << Click Here >> for more details...
tell 2 reasons for why only copper is used in domestic
wires& only alluminium in transmission lines ?
- 10 Answers
- 17812 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / suresh
the same for home &
in transmission we have to transmit long distance if we use
copper its(costly&weight)when compared to alum.& distance
b/w the pole is decrease
and due to capacitive sending end Volt SEV < REV if v use
alum some Wat it will reduce.( HV the current flow around
the cable not inside the wire y should v use costly
copper).in LV current flow inside the cable
| Is This Answer Correct ? | 0 Yes | 7 No |
Post New Answer View All Answers
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
Swg formulae
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
what is circuit recombiner and how it is different from circuit breaker
If i am running of spindle at 2000rpm ,but How to spindle stop at the second I am resetting the machine in CNC machines
How much of the total hydro power potential has been exploited so far in india?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
wish of these transformer uses oil?
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
Why syn. Generators are used for the production of electricity?
why need to be maintain power factor for industrial customer?
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
what is negative d.c. voltage, why this voltage is used in base transciever station.
