Why we connect the capacitor in Delta?if we conect in Star
what will happen?
Answer Posted / t. eswara rao
Capacitors are used for compensating the inductive reactive
power in the system and bring the power factor to the unity.
But the question is what is problem if we connect them in star?
If we connect them in star , and any capacitor fails ,
it momentarily shorts the supply voltage and raises the
voltage levels across the remaining capacitor banks
connected in the remaining phases. This may lead to destroy
the other two capacitor banks also.
Is This Answer Correct ? | 32 Yes | 10 No |
Post New Answer View All Answers
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
what parameters should we check to reduce the power bill
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
How many types of protection relays are there based on the characteristic?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
what & how to check the lightning arrester
What is the difference between UPS & inverter ? which UPS is better and whos got the edge ? what is the difference between & inverter ? which UPS is better and whos got the edge 12 V , 24 V , 36 V etc what are the advantages of 12 V, 24 V , 36 V etc and what are the disadvantages of 12 V, 24 V, 36 V etc thanks
why zero sequence impedance measurement is not applicable for single phase GT
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
Why the symbol of register is "zig zag"
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?