Interested to Buy Any Domain ? << Click Here >> for more details...
HOW TO CHECK THERMOCOUPLE AND RTD & WHAT IS THE DIFFERENCE
BETWEEN THERMOCOUPLE AND RTD
- 14 Answers
- 99336 Views
- I also Faced
- E-Mail Answers
Answer Posted / binu
Thermocouple when senses gives "mv" readings to the
transmitter. RTD gives "ohm" readings to the transmitter.
For checking put the multimeter in resistance mode and if
the the sensor is throcouple the meter will indicate
almost"0" resitance whereas the RTD would indicate
around "119 ohms" in normal temperature like 30deg.C
| Is This Answer Correct ? | 248 Yes | 26 No |
Post New Answer View All Answers
which type of signal used in instrument?
How to calibrate capillary type level transmitter
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
what is the difference between scaler and vector drive
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
Why grounding is necessary? Give example with diagram.
how many types of preheaters are in cement industry & what r they can any body explain?
What is instrumentation instrumentation engineering?
How d.p. Transmitter can be applied to open tank?
Dear Sir/Madam,im going to attend Hpcl written exams on feb 17th in instrumentation stream..can anyone send me the HPCL model papers and pattern of HPCL ....i ve not yet attended anything in HPCL...so i dont know how it comes...so just i need some model test papers and pattern ..pls help me friends...
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
Why boiler chimney area oxyden sensor fixing?
Why plc require in analog input 4-20amp & 0-10 volt?
