Interested to Buy Any Domain ? << Click Here >> for more details...
A differential transmitter is calibrated to measure the
flow of lquied, explain what wil happen if the fluid is not
pure but contains some bubble?
- 2 Answers
- 6827 Views
- I also Faced
- E-Mail Answers
Answer Posted / binu
If bubbles are there then the flow meter will show erratic
reading. Best way to get an errorless reading is to have a
air release valve in the upstream side of the flow meter so
that these bubbles can be removed from the line before
entering into FM.
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
what is the criteria to decide conductor size of a cable ?
Which language of programing is popular? how can i learn it ?
What is furnace draft control?
Explain bernoulli’s theorem.
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What is hp & mp seperator .& what is its working principle ?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
if my flow is 20000 m3/h than which range of DPT i have to use????
Full form of KKS when use DCS.
Differentiate between ultrasonic flowmeter and radar type flow meter
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
whats the abbreviation of IOP? is it instrument of power or input open problem?
Manipulation of dead wt. tester double piston type.
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
