Interested to Buy Any Domain ? << Click Here >> for more details...
why dc power can not be used in transformer?
- 33 Answers
- 69606 Views
- GE, Sail, I also Faced
- E-Mail Answers
Answer Posted / kumar
Bcoz if u given dc supply 2 transformer input, current
increases infintly large & due to magnetostiction effect
the winding of transformer burns out
| Is This Answer Correct ? | 9 Yes | 10 No |
Post New Answer View All Answers
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
How to Prepare preventive maintenance shedule of machine tool.
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
how to calculate the cable current ratingand and how much of distance the rating will be ok will the distance is incresed what the action we take
How much weight an electrical engine can pull??
What is a single phase autotransformer?
what is the principle of operation of tungstun bulb ??
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What is meant by analogous system?
how many joint can done in HT line and what is life of the joint
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
how to determine ct ratio in ht vcb?
