Interested to Buy Any Domain ? << Click Here >> for more details...
There are a Transformer and an induction machine. Those two
have the same supply. For which device the load current
will be maximum? And why?
- 4 Answers
- 11231 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashokkumar gc
In both the machines output(load) current deponds on it's
load & it's max load current deponds on rating of motor &
transformer..
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
WHAT HAPPENED DC SERIES MOTOR FIELD WINDING OPEN. CAN POSSIBLE.
what about GD square and its important for motor design?
Why derivative controller is not used in control systems?
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
How vfd saving power.
What is the difference between the impedance percent and impedance voltage ?
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
What is the end effect of linear induction motor ??
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
what is the use of the circle diagram
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
