A rotor of an induction machine is delta connected. Now is
there any necessacity to short the slip rings?
- 8 Answers
- 10208 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / victorvgp
r u sure in this question?
if rotor is delta connected then, why slip rings r there?
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
standard earthing rating for power line..
How RTCC panel is working and give single line diagram for RTCC with transformer?
How to calculate earth wire load by formula
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
what are the Alarm, Trip & Safety equipment (Issues) present in Power Transformers pls Mail it to ashokbabunhce@gmail.com
Between educational qualification and practical work experience, give us a brief explanation on your practical experience in your past Endeavour that you performed well to the satisfaction of your past or present employer?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
kindly send me 11KV MV motor differential protection procedure by primary injection method.
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
Any Electrical Engineering jobs?Please refer for interviews. Thank you
