What is the purpose of starter and choke in tube light?
- 9 Answers
- 109824 Views
- Chimay Brewery, TATA, TSPL, I also Faced
- E-Mail Answers
Answer Posted / rajendra singh
The purose of starter and choke in tube light circuite,for
start-up the tube lights.
The choke work as a blastand induced 850V to 1100V in
starting,by strarter make and break of the circuite. After
glowing the tube light choke work as inductance and provide
110v to circuite.
| Is This Answer Correct ? | 204 Yes | 56 No |
Post New Answer View All Answers
how to deside the capacity of chock for drive?
why impedance relay is used for medium transmission line protection
How shall i select the value of capacitor or inductor in a system?
what is mind in cable
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
What does bode plots shows?
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
What is the difference between security constraint unit commitment and security constraint optimal power flow?
What is the purpose of stablization resistor in high impedance bus bar protection
what type of motor used to move a 1 ton gate? and relate ratings with load.
i need about 10 years of GATE solved papers in pdf format and even mock tests toooo
how to size H.T & L.T Panel ?
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
What are the three constants associated with a steady state error?
