Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / d b pathak
BY ONAF
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
what parameters are should nessary for control technic dc drive(in rolling mills)?
When we need up only in o/p 440v, so why we use directly in 11kva in input?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
who can measure the size of power cable?
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
how to calculate fault level?
How would your past experience translate into success in this job?
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
What is the Resposiblity of Electrical Utility Engineer
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
Can we transmit digital signal to long distance ?
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
