Answer Posted / sam
I'm assuming something like
R0 EQU 0
R1 EQU 1
:
Rx EQU x
is coded somewhere in the program
| Is This Answer Correct ? | 2 Yes | 26 No |
Post New Answer View All Answers
How are data passed from jcl parm to assembler program?
What does the following code do? Ap wkur,=p5 where wkur is a label?
Explain the difference in data type "x" and "p"?
How to pass the parameters from jcl to assembler program?
Explain about house keeping in assembler?
how to pass the parameters from jcl to assembler pgm?
Explain how to produce soc7 abend?
how to initialize a register to 0000?
In the house keeping section of an MVS assembly language program, like the one below STM R14,R12,12(R13) BASR R12,R0 USING *,R12,R11 LA R11,2048 LA R11,2048(R11,R12) .... .... 1. What if BASR R12,R0 IS NOT PRECEDE USING *,R12,R11? 2. USING (base address), REGISTER does USING directive says assembler to treat particular Register as a base register with the mentioned base address..in the above case * i.e current location counter..well if that is the case why we need BASR R12,R0 ? 3. What if I write like STM R14,R12,12(R13) BASR R12,R0 LA R11,2048 LA R11,2048(R11,R12) USING *,R12,R11 there is no address resolution being calculated in both LA statements so is it a right way to set Base register?..will there be any issues with Domain regarding R11 and R12?
How many maximum base registers we can have in a single program?
How do you round the addition or subtraction of two numbers in assembler?
Explain about base register?
how do you round the addition or subtraction of two numbers in assembler? what does the following code do? change process tool(code changes from dev to prd) the changes made to your code should be effected in live. How the process takes place. That is how can you move the code changes from development to production?
What is the use of trt instruction?
What does "using" do?
