Answer Posted / b.bhaskar reddy
The effect of armature conductors flux on main field flux
is called armature reaction.due to armature reaction
(i)reduction of mainfield flux and distorion of flux in to
air gap perifery.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
Can I use distributon class/transmission class Lightning arresots for protecting the building? If not why please explain?
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
How do you compute voltage drop and cable size over distance?
how the characterstics of control valve being done
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
how withstand of hi-pot test outputs of transformer wire 2.5mm
What are the advantages of hydropower?
What are root loci?
What is limitedly stable system?
Different types of relay fault which phase sequence??
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
How to calculate MCB Breaking capacity.
why constant voltage transformer should be start without load? and if started then what will happen?
