Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / r.vijayan
DCS is Nothing but Distributed control System which will be
mainly used in process industries to control a entire plant
operation. The entire plant will be diveded into sub areas
and each will be controlled by separate PLC and all these
PLCs are integrated into one supervisory system where
operator contol and monitoring action takes place.
We can as simply that DCS = SCADA + PLCs.
| Is This Answer Correct ? | 63 Yes | 14 No |
Post New Answer View All Answers
Any one can help me to identified, how can we interchange the device in FF
what is the difference between magnetic flow meter and mass flowmeter
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
what is intrinscily safe system and where we use?
How to calibration a control valve?
What is profibus?
How to Calibrate Vibration Probe (Axial, Redial) in field
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
How to calibrate smoke Dectector
What is the use of temperature compensation?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
What is three element drum level control system why its better than single element?
What is the basic difference between Modbus and CAN Open Protocols
