Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rakeshsingh41
maximum genarating in india 500MW.
| Is This Answer Correct ? | 7 Yes | 20 No |
Post New Answer View All Answers
define as synchronous generator
what is the affect of earth's magnetic field on the frequency used in aircraft???
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
What is the difference between indoor and outdoor transformer
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
when elecromagnatic waves are propogated in a wave guide?
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
Why High voltage are generate noise ?
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
