Interested to Buy Any Domain ? << Click Here >> for more details...
why transformer ratings in kva?
- 99 Answers
- 231710 Views
- Bhel, College School Exams Tests, DOW, Emco, Esab, GE, KCP, PGCVL, Sodexo, TCS, vtps, Wipro, I also Faced
- E-Mail Answers
Answer Posted / s saranraj(sri durgadevi polyt
Both the losses of the transformer is independent of the
power factor (cos phi), which means a transformer would not
make any change in the power factor, since both the losses
viz copper loss(depends on current) and iron loss(depends
on voltage) are independent of power factor, that is why a
Transformers rating is not on kW, but on KVA
(or)
because,ironloss is depends in voltage and cu_loss is
depends in current.so the transformer ratings in kva
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Whata are the types of Cables?
whati s the sludge current in ups
What is essential to prove safe isolation of electrical circuit?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
How many kw will suply from one db
What are the different circuits in thermal power plant?
how can we design robots
what is thresold of perception
what is two point starter?
Please brief working principle & construction of permanent magnet AC Servo motor
What is difference between safe PLC and normal PLC
What is the difference between electrical earthing and electrical grounding?
block diagram of 2 ups system connected in hot stand by mode?
is there any phase difference occurs while primary and secondary side mutual induction occurs?
