Answer Posted / tauseef tarique, engineer(e)
kV (Kilo Watt) is the unit of measurement of electrical
power. While kV is the unit of measurement of voltage
(potential difference).
for the three phase supply
kW= 1.732xVxIxcos phi
where V= Voltage
I= Current
Cos phi= power factor
For single phase supply
kW= VxIx cos phi
| Is This Answer Correct ? | 16 Yes | 6 No |
Post New Answer View All Answers
What is the efficiency during maximum power transfer?
why does rotor rotets?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
What are PLC leader logic program method
What is Bolted fault?
Why the field rheostat is adjusted such that the voltmeter reads 380V
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
Why need 3phase machine double earthing?
how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt
please send me the L&T Emb. sys. placement papers and entire details of pattren
How to improve fuel cell in a distribution system?
In CTs tan delta point should be earthed , what is the reason behind it?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
Why we use duplex coil and hook switch in telephone system?
