Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.k.rameshkumar
1.Corner taps
2.Flange taps
3. D and D/2 taps
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Explain Gas Turbine startup and shutdown sequences
field bus transmitter calibration procedure tell me
What is PDS and PDMS ?
What is the use of temprature compensation?
how do calibrate the valves.. with clear manual
Which topics are covered in Process Control?
Isometric drawings are generated during _________________ phase of a project
what is the calibration procedure for transweigh make weigh feeder?
How do bending tubing provide better measurement than using tubing fittings such as elbows?
I have energy meter for educational project having 0.5s class but my friend need 0.2s class meter , which one is good for that purpose and what is the actual difference of that two classes , need very easy example also.??
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
