what is power factor? whether it should be high or low? why?
- 11 Answers
- 13346 Views
- I also Faced
- E-Mail Answers
Answer Posted / gurpreet sandhu
POWER factoris the cosine angle between Voltage and current
or it is the ratio of true power to apperant power
| Is This Answer Correct ? | 24 Yes | 0 No |
Post New Answer View All Answers
what is gridrotor resistance starter
The power factor of the fixed load is 0.8, now the p.f is varying from 0.8 to 0.5.
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
If not into production, how far did you follow the design and why did not you see it into production?
How we can calculate the life of Lead acid battery
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
What is the RME and explain the full form and what is the RME work?
What is core CT & it's function?
description with working of all parts of a Diesel generator???????
all details of DG UPS HVAC
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
Which device is used for the source of emission of electrons in a crt?
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
