Interested to Buy Any Domain ? << Click Here >> for more details...
why dc power can not be used in transformer?
- 33 Answers
- 69561 Views
- GE, Sail, I also Faced
- E-Mail Answers
Answer Posted / victorvgp
Dc transformers are also available in markets
| Is This Answer Correct ? | 8 Yes | 35 No |
Post New Answer View All Answers
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
what is meant by residual over voltage & residual earth fault ?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
Which type of DG need Netral Earthing?
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
what is meant by neutral compensation factor and where it is used
how can i get the formula to find out the cable size if i know the load of main fuse protection.
What are the conditions to be satisfied for parallel operation of dc generators?
What are the advantages and disadvantages of short-pitched winding?
Why are the laminations insulated from each other?
