Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between between open delta and
broken delta?
- 5 Answers
- 28923 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / sanjeet swarnakar
in open delta between there is no follow of current
But in broken delta 57 % load current folow between two
phases ...............
| Is This Answer Correct ? | 12 Yes | 28 No |
Post New Answer View All Answers
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
what is the difference betweem star connected motor & delta connected motor?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
What is speed mode?
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
what are the problems that generally occur in power flows??
block diagram of 2 ups system connected in hot stand by mode?
how we decide scurt (disc) of insulator with respect to kv rating
How will change the frequency in distribution side?
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
