Interested to Buy Any Domain ? << Click Here >> for more details...
Give two basic sprrd control scheme of DC shunt motor.
- 2 Answers
- 6025 Views
- I also Faced
- E-Mail Answers
Answer Posted / sindhu
1. by using flux control method:in this method a rheostat is connected across the field wdg to control the field current.so by changing the current the flux produced by the field wdg can be changed, and since speed is inversely proportional to flux speed can be controlled
2.armature control method:
in this method a rheostat is connected across armature wdg.by varying the resistance the value of resistive drop(IaRa)can be varied,and since speed is directly propotional to Eb-IaRa the speed can be controlled
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
can we synchronize star system generators with delta system transmission line ? and how ?
What type of fittings and electrical accessories can be install in radiation area ?
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
What are the common sources of energy?
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
I want the details about BHEL company examination.Can anyone able to help me please.
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
What is phenomenon of electromagnetic induction and how it works?
what is the difference between rectifier and converter and commudator?
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
sugest any typical project ?
