how the harmonics are generated in transforemer?
- 5 Answers
- 8992 Views
- IFFCO, I also Faced
- E-Mail Answers
Answer Posted / sathish
harmonics generated by nonlinear loads is presented
| Is This Answer Correct ? | 28 Yes | 3 No |
Post New Answer View All Answers
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.
What is the use of lag compensator?
how to determine ct ratio in ht vcb?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
Which is the largest hydropower station in the world?
Pls mail me utility & Dg related question with answer
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
limitation of conductor height on ground when we consider EMC
before synchronizing an alternator,power factor is leading ,why?
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
How to Calculate Transformer Earthing Electrode Rod Size both Body and neutral Earthing ? Any Standard Formula? Please Suggted
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
Mention the methods for starting an induction motor?
