What is the acessaries distribution transformer ?
- 11 Answers
- 15230 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / sanoj
BUCHOLZ RELAY, WINDING/OIL TEMP INDICATORS ETC ARE SEEN ONLY
IN POWER TRANSFORMERS. IN DISTRIBUTION TRANSFORMERS, THERE
WILL BE TR. TANK WITH CONSERVATOR, BREATHER, BUSHINGS ETC.
PROTECTION IS PROVIDED WITH D.O. FUSE IN PRIMARY AND
ORDINARY PORCELAIN FUSE IN SECONDARY. PROTECTION AGAINST
LIGHTNING IS PROVIDED THROUGH LIGHTNING ARRESTORS.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
WHAT IS ELECTRICAL MAINTAINTENCE ?
reason of diode failure in alternator
Why air circuit breaker off due to power failure?
in star-delta tranformer,if the input of star connection is 400/7v 3 kva then what is the output of delta connection?
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What is the difference between PLC and Embeded system
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
How many devices can be connected in one zone of FACP
How would your past experience translate into success in this job?
